ABB IRB 5720 Product Manual page 220

5 Repair
5.5.1 Replacing the arm house cover including the axis-4 cassette sealing
Continued
Removing the cable harness from the wrist and upper arm
1
2
3
Continues on next page
220
Action
Foundry Plus, DressPack:
Remove the cover.
Note
Use caution not to damage the gasket.
Tip
Use tape and tie the axis-5 and axis-6
connectors and carrier into a bundle (if not
already done). This is done to facilitate the
removal and to avoid damaging the parts.
This will also make it easier to run the cable
harness through the inside of the upper
arm.
Remove the side cover on the arm tube.
© Copyright 2022 ABB. All rights reserved.
Note
Foundry Plus
xx2000000422
DressPack
xx2100002679
xx1300000668
xx2000000420
Product manual - IRB 5720
3HAC079195-001 Revision: A