ABB IRB 5720 Product Manual page 363

6
7
8
Refitting the motor
Use these procedures to refit the motor.
Preparations prior to refitting motor
1
2
Product manual - IRB 5720
3HAC079195-001 Revision: A
Action
CAUTION
Whenever parting/mating motor and gear-
box, the gears may be damaged if excess-
ive force is used.
Press the motor out of its position by using
the removal tool in opposite holes of the
motor.
CAUTION
The weight of the motor is 13 kg
All lifting accessories used must be sized
accordingly.
Remove the motor by sliding it out on the
guide pins and lift it off.
Tip
Make a note in which direction the cable
gland hole is facing. The motor shall be
refitted in the same position.
Action
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
Remove any old paint or flange sealant residues
or other contamination from the contact surfaces
on both the motor and the mating parts.
Tip
Remove flange sealant residues with Loctite 7200.
Then use Loctite 7063 for cleaning the mating
surface.
© Copyright 2022 ABB. All rights reserved.
5.8.3 Replacing the axis-3 motor
Note
Removal tool motor M12: 3HAC14631-1
Used to push out the motor, if necessary.
Always use removal tools in pairs.
xx2100002149
Make sure the pinion is not damaged.
Note
Continues on next page
5 Repair
Continued
363