How To Read The Parameter List; Icons And Terms That Identify Parameters And Control Modes - YASKAWA CIPR-GA50C series Technical Manual
Ac micro drives for industrial applications. 200 v class, three-phase input: 0.1 to 22 kw. 200 v class, single-phase input: 0.1 to 4.0 kw. 400 v class, three-phase input: 0.37 to 30 kw.
Hide thumbs
Also See for CIPR-GA50C series:
- Installation and operation instruction manual (310 pages) ,
- Technical manual (794 pages) ,
- Installation and operation instruction manual (79 pages)
Table of Contents
Advertisement
11.2
How to Read the Parameter List
◆
Icons and Terms that Identify Parameters and Control Modes
Icon
V/f
The parameter is available when operating the drive with V/f Control.
OLV
The parameter is available when operating the drive with Open Loop Vector Control.
OLV/PM
OLV/PM
The parameter is available when operating the drive with Open Loop Vector Control for PM.
AOLV/PM
The parameter is available when operating the drive with Advanced Open Loop Vector Control for PM.
EZOLV
The parameter is available when operating the drive with EZ Open Loop Vector Control.
Hex.
Hexadecimal numbers that represent MEMOBUS addresses to change parameters over network communication.
RUN
The parameter can be changed settings during run.
Expert
The parameter that is available in Expert Mode only.
*1
Set A1-01 = 3 [Access Level Selection = Expert Level] to display and set Expert Mode parameters on the keypad.
Note:
Gray icons identify parameters that are not available in the specified control method.
YASKAWA SIEPC71061753A GA500 Technical Manual
11.2 How to Read the Parameter List
Description
*1
11
335
Advertisement
Table of Contents
Troubleshooting
