Avaya S8700 Maintenance Manual page 366

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

Maintenance Commands

Field Descriptions

Interface Link

Session Local

Session Remote

Issue 1 May 2002

Type y to enable a processor channel. Type n (default) to disable a

processor channel.

Identifies the switch application used over this link. The application

gateway is used for conversion between ISDN and TCP/IP. Valid entries

are: audix, dcs, fp-mwi, gateway, gtwy-tcp, mis, msaamwl, msaclk,

msahlwc, msallwc, msamcs, qs-mwi, blank (default)

Identifies which processor channel the given processor channel is serving

as a gateway to. Valid entries are a number between 1-(maximum number

of processor channels), or blank (default).

Identifies whether the IP session is passive (client) or active (server). This

field must be blank if the type of interface link is x.25 (r model) or procr-intf

(si model). This field cannot be blank if the type of interface link is ethernet

or ppp. Valid entries are client, server, or blank (default).

Identifies the physical link carrying this processor (virtual) channel. Links

numbered 1 through (4 times the number of PI circuit packs) for the si

model can be either x.25 or tcp/ip. The rest of the links (up to 25) must be

Identifies the switch or adjunct at the far end of this link. Enter an adjunct

name, switch name, far-end IP address, node ID, or leave blank (default)

for services local to this switch.

Identifies the port number of the destination. The number 0 means any port

can be used. Valid entries are 0 (default), 5000-64500.

Field ported forward from R6.

Troubleshooting