Show Debugging - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

S C M
YSTEM ONFIGURATION AND

SHOW DEBUGGING

show debugging
Overview This command displays information for all debugging options.
For information on filtering and saving command output, see the
with AlliedWare Plus" Feature Overview and Configuration
Syntax show debugging
Default This command runs all the show debugging commands in alphabetical order.
Mode User Exec and Privileged Exec
Usage This command displays all debugging information, similar to the way the
tech-support
authorized service personnel only.
Example To display all debugging information, use the command:
awplus#
Output Figure 5-4:
613-50157-01 Rev C
C
ONITORING OMMANDS
command displays all show output for use by Allied Telesis
show debugging
Example output from the show debugging command
awplus#show debugging
AAA debugging status:
Authentication debugging is off
Accounting debugging is off

% DHCP Snooping service is disabled

802.1X debugging status:

EPSR debugging status:
EPSR Info debugging is off
EPSR Message debugging is off
EPSR Packet debugging is off
EPSR State debugging is off

IGMP Debugging status:
IGMP Decoder debugging is off
IGMP Encoder debugging is off
...
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
"Getting Started
Guide.
show
201