Device Server; Appendix B Hardware Recommendations; Table 27: Device Server Ram Requirements For Firewall/Vpn Or Junos; Table 28: Device Server Ram Requirements For Idp, Secure Access, Or Infranet Controller Devices - Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual

Device Server

Copyright © 2010, Juniper Networks, Inc.
Table 26: GUI Server RAM Requirements (continued)
Total Config Size
Between 10 and 50 MB
More than 50 MB
After the installation, Juniper recommends that you make the following change on the
server machine/(s):
In the
/var/netscreen/GuiSvr/guiSvr.cfg
guiSvrDirectiveHandler.max.heap
the change, restart Gui Svr.
The key factor in determining the memory requirements for the Device Server is the
number of devices you are managing. Use Table 27 on page 203 to determine the
requirements for a given deployment size if the Device Server is managing firewall/VPN
devices or Junos devices.

Table 27: Device Server RAM Requirements for Firewall/VPN or Junos

Devices
Number of Devices
Less than 200
More than 200
Use Table 28 on page 203 to determine the requirements for a given deployment size if
the Device Server is managing IDP standalone devices that are performing profiling
operations, Secure Access devices, or Infranet Controller devices.
Table 28: Device Server RAM Requirements for IDP, Secure Access, or
Infranet Controller Devices
Number of Devices
1 through 3
4 through 8
9 through 30
After the installation, Juniper recommends that you make the following change on the
server machine/(s):
GUI Server RAM Required
6 GB
8 GB
file, change the value of
from 1024000000 to 1536000000. After implementing
Device Server RAM Required
4 GB
6 GB
Device Server RAM Required
4 GB
6 GB
8 GB
Appendix B: Hardware Recommendations
203