Member Interface - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

member interface

Syntax
Release Information
Description
Options
Mode
Related Topics
1300
[ no ] member interface interfaceType interfaceSpecifier
Command introduced before JunosE Release 7.1.0.
Adds a member VLAN or S-VLAN subinterface to a Martini layer 2 circuit associated with
a load-balancing group. This command creates an MPLS shim interface and associates
it with the group. The no version removes the member subinterface from the circuit.
Repeat as needed to remove all member subinterfaces used by a load-balanced circuit,
thereby deleting the circuit from the group.
interfaceType—One of the following interface types listed in Interface Types and
Specifiers on page 5
serial
pos
interfaceSpecifier—Particular interface; format varies according to interface type; see
Interface Types and Specifiers on page 5
L2 Transport Load-Balancing-Circuit Configuration
Configuring CE-Side Load Balancing for Martini Layer 2 Transport in the JunosE BGP and
MPLS Configuration Guide
Copyright © 2010, Juniper Networks, Inc.