Adding Member Interfaces To An Interface Set; Adding Interfaces To An Interface Set With The Cli - Juniper JUNOSE 11.1.X - QUALITY OF SERVICE CONFIGURATION GUIDE 3-21-2010 Configuration Manual

JUNOSe 11.1.x Quality of Service Configuration Guide
2.
Related Topics

Adding Member Interfaces to an Interface Set

You can add interfaces as members of an interface set using the CLI or RADIUS.
Tasks to add members to an interface set include:

Adding Interfaces to an Interface Set with the CLI

To add subscriber interfaces to the interface set:
1.
2.
214
Adding Member Interfaces to an Interface Set
Delete the interface set from the interface superset.
host1(config-qos-interface-superset)#no qos-interface-set atm-vc-data
For more information about configuring interface supersets, see Configuring
Interface Supersets for QoS on page 212
Monitoring the Configuration of QoS Interface Sets on page 350
member-interface-type
qos-interface-parent
qos-interface-set
restricted
Adding Interfaces to an Interface Set with the CLI on page 214
Adding Interfaces to an Interface Set with RADIUS on page 215
Changing and Deleting Interface Members in an Interface Set on page 215
Changing Interface Members with Upper-Layer Protocols in an Interface
Set on page 215
Specify the VLAN or ATM-VC subinterface you want to add to the interface set.
For VLAN subinterfaces:
host1(config)#interface gigabitEthernet 4/0/0.1
For ATM subinterfaces:
host1(config)#interface atm 2/0/0.1
host1(config-sub-if)#atm pvc 21 0 21 aal5snap
Configure the interface set as the parent of this interface.
host1(config-sub-if)#qos-interface-parent residential-customers
The interface type must match the member-interface type specified in the
interface set.