Mdl Transmit - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
JunosE 11.2.x Command Reference Guide A to M
mdl transmit
Syntax
Release Information
Description
Options
Mode
1294
[ no ] mdl transmit { path-id | idle-signal | test signal }
no mdl transmit
Command introduced before JunosE Release 7.1.0.
Transmits an MDL message from a T3 interface. The no version disables transmission
of the specified MDL message or all MDL messages.
path-id—Transmits a path identification message every second; default value is disabled
idle-signal—Transmits an idle signal message every second; default value is disabled
test-signal—Transmits a test signal message every second; default value is disabled
Controller Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?