Table of Contents
Advertisement
A-4
A
A: IP M
PPENDIX
Displaying
Multicast Interfaces
Top-Level Menu
system
interface
dvmrp
ethernet
route
display
igmp
fddi
arp
enable
tokenring
interface
multicast
disable
bridge
tunnel
udpHelper
ip
routeDisplay
routing
cacheDisplay
ipx
icmpRouterDiscovery
appletalk
rip
snmp
ping
analyzer
statistics
script
logout
Index
Local Address
1
158.101.112.32
R
ULTICAST
OUTING
Rate Limit
The rate limit determines how fast multicast traffic can travel over the
interface in kilobytes per second. Multicast traffic may not exceed this rate
limit or the CoreBuilder system will drop packets in order to maintain the
set rate. The default is set to 0, which implies no rate limit. In all other
instances, the lower the rate limit, the more limited the traffic over the
interface.
To display a multicast interface:
1 From the top level of the Administration Console, enter:
ip multicast interface display
2 Enter the slot of the switching module from which you want to display a
multicast interface.
Select IP stack(s) by slot (2,3,7,9-12|all) [12]:
Enter the index numbers of the interfaces you want to display.
Example multicast interface configuration for the slot:
Metric
1
pkts
port
port
port
Threshold
RateLimit
1
0
in:0
pkts out:0
3
peers
158.101.112.204
158.101.112.202
3 groups
224.2.127.255
224.2.143.24
4 groups
224.2.143.24
224.2.127.225
State
queries
(3.6) (0x8e)
(3.6) (0x8f)
(3.6) (0x8e)
Advertisement
Table of Contents
