Regulator Valve Body Disassembly, Inspection, And Reassembly - Honda 2004 Odyssey Service Manual

Regulator Valve Body Disassembly, Inspection, and Reassembly

1. Clean all parts thoroughly in solvent or carburetor cleaner, and dry them with compressed air. Blow out all
passages.
2. Check all valves for free movement. If any fail to slide freely, refer to Valve Body Repair (see page 14-196).
3. Replace the valve body as an assembly if any parts are worn or damaged.
4. Hold the regulator spring cap in place while removing the stop bolt. The regulator spring cap is spring loaded.
Once the stop bolt is removed, release the spring cap slowly so it does not pop out.
5. Reassembly is the reverse of disassembly. Install the filter in the direction shown.
6. Coat all parts with ATF during reassembly.
7. Align the hole in the regulator spring cap with the hole in the valve body, then press the spring cap into the valve
body, and tighten the stop bolt.
REGULATOR SPRING CAP
LOCK-UP TIMING VALVE
VALVE CAP
VALVE CAP CLIP
SPRING SPECIFICATIONS
No. Spring
Stator reaction spring
Regulator valve spring A
Regulator valve spring B
Lock-up control valve spring
Lock-up timing valve spring
LOCK-UP CONTROL VALVE
VALVE SLEEVE
Standard (New)-Unit: mm (in.)
Wire Dia. O.D.
5.5 (0.217) 37.4 (1.472)
1.9 (0.075) 14.7 (0.579)
1.6 (0.063) 9.2 (0.362)
0.8 (0.031) 6.6 (0.260)
0.65 (0.026) 6.6 (0.260)
REGULATOR VALVE
STOP BOLT
6 x 1.0 mm
12 N·m (1.2 kgf·m, 8.7 lbf·ft)
REGULATOR VALVE BODY
Inspect for scoring and
damage.
FILTER
Install in this direction.
Free Length
30.3 (1.193)
77.4 (3.047)
44.0 (1.732)
44.3 (1.744)
34.8 (1.370)
No. of Coils
2.12
15.2
12.5
25.5
15.6
14-201