Fuel Pressure Regulator Replacement; Fuel Filter Replacement - Honda Accord 2008 Manual

07/11/02 09:18:35 61TA0000_110_0376
Fuel Supply System
Fuel Pressure Regulator
Replacement
1. Remove the fuel tank unit (see page 11-373).
2. Remove the reservoir (A).
＊０１
3. Remove the bracket (B).
4. Remove the fuel pressure regulator (C).
5. Install the parts in the reverse order of removal
with new O-rings (D) and a new bracket. When
installing the fuel tank unit, align the marks on the
unit and the fuel tank (see page 11-374).
NOTE:
• Coat the O-rings with clean engine oil; do not use
any other oils or fluids.
• Do not pinch the O-rings during installation.
• Use all the new parts supplied in the pressure
regulator replacement kit.
11-376 11-376
ＴＡ０８ＡＥ４Ａ２０３２６４２８２０１ＫＢＡＴ００

Fuel Filter Replacement

The fuel filter should be replaced whenever the fuel
pressure drops below the specified value (see page
11-361), after making sure that the fuel pump and the
fuel pressure regulator are OK.
1. Remove the fuel tank unit (see page 11-373).
2. Remove the fuel filter set (A).
D
C
B
D
A
E
D
3. Check these items before installing the fuel tank
unit:
• When connecting the wire harness (B), make
sure the connection is secure and the connectors
are firmly locked into place.
• When installing the fuel gauge sending unit (C),
make sure the connection is secure and the
connector is firmly locked into place. Be careful
not to bend or twist it excessively.
4. Install the parts in the reverse order of removal
with new O-rings (D) and a new bracket (E). When
installing the fuel tank unit, align the marks on the
unit and the fuel tank (see page 11-374).
NOTE:
• Coat the O-rings with clean engine oil; do not use
any other oil or fluid.
• Do not pinch the O-rings during installation.
• Use all the new parts supplied in the fuel filter
replacement kit.
ＴＡ０８ＡＥ４Ａ２０３２６４２７６０１ＫＢＡＴ００
A
B
＊０１
C