Throttle Body Test - Honda Accord 2008 Manual

07/11/02 09:19:10 61TA0000_110_0384
Intake Air System

Throttle Body Test

Carbon Accumulation Check
NOTE: If the malfunction indicator lamp (MIL) has been
reported on, check for diagnostic trouble codes (DTCs).
1. Connect the HDS to the data link connector (DLC)
(A) located under the driver's side of the dashboard.
＊０１
2. Turn the ignition switch to ON (II).
3. Make sure the HDS communicates with the ECM/
PCM. If it doesn't, go to the DLC circuit
troubleshooting (see page 11-208).
4. Start the engine. Hold the engine speed at
3,000 rpm without load (A/T in P or N, M/T in
neutral) until the radiator fan comes on, then let it
idle.
5. Check the REL TP SENSOR in the DATA LIST with
the HDS. The reading should be below 3 deg. If it is
not, clean the throttle body (see page 11-385).
11-384
A
Throttle Position Learning Check
NOTE: If the malfunction indicator lamp (MIL) has been
reported on, check for diagnostic trouble codes (DTCs).
1. Connect the HDS to the data link connector (DLC)
(A) located under the driver's side of the dashboard.
A
2. Turn the ignition switch to ON (II).
3. Make sure the HDS communicates with the ECM/
PCM. If it doesn't, go to the DLC circuit
troubleshooting (see page 11-208).
4. Select the INSPECTION MENU with the HDS.
5. Do the TP POSITION CHECK in the ETCS TEST. If
needed, clean the throttle body (see page 11-385).
ＴＡ０８ＡＥ４Ａ２０３３６３５９４０１ＦＥＡＴ００
＊０２