Throttle Body Removal/Installation - Honda Accord 2008 Manual

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:19:12 61TA0000_110_0388

Intake Air System

Throttle Body Removal/Installation

Do not insert your fingers into the installed throttle body when you turn the ignition switch to ON (II) or while the

ignition switch is ON (II). If you do, you will seriously injure your fingers if the throttle valve is activated.

NOTE: If you are replacing or cleaning the throttle body, start at step 1. If you are removing the throttle body, start at

1. Connect the HDS to the DLC while the engine is stopped.

2. Select the INSPECTION MENU on the HDS.

3. Do the TP POSITION CHECK in the ETCS TEST.

4. Turn the ignition switch to LOCK (0).

5. Remove the intake air duct (A).

6. Disconnect the throttle body connector (B).

7. Disconnect and plug the water bypass hoses (C).

8. Remove the throttle body (D).

9. Install the parts in the reverse order of removal with a new gasket (E).

NOTE: When torquing the screw of the hose band (F), align the edge of the hose band (G) with the mark (H)

painted on the hose band.

After installing the throttle body, check these items:

• Do the ECM/PCM idle learn procedure after replacing the throttle body (see page 11-343).

• Refill the radiator with engine coolant (see page 10-6).

ＴＡ０８ＡＥ４Ａ２０３３６３５９４０１ＫＤＡＴ００

(2.2 kgf·m, 16 lbf·ft)

Table of Contents