Valve Body
Main Valve Body Disassembly, Inspection, and Reassembly
1. Clean all parts thoroughly in solvent or carburetor cleaner, and dry them with compressed air. Blow out all
passages.
2. Do not use a magnet to remove the check valve ball; it may magnetize the ball.
3. Check all valves for free movement. If any fail to slide freely, refer to Valve Body Repair (see page 14-196).
4. Replace the valve body as an assembly if any parts are worn or damaged.
5. Coat all parts with ATF during assembly.
6. Install the filter in the direction shown.
MAIN VALVE BODY
Inspect for scoring and
damage.
REVERSE CPC
VALVE
VALVE
SLEEVE
MANUAL VALVE
VALVE CAP CLIP
14-198
MODULATOR VALVE
FILTER
Install in this direction.
SERVO CONTROL VALVE
SHIFT VALVE C
SHIFT VALVE D
RELIEF VALVE
COOLER CHECK VALVE (BALL)
TORQUE CONVERTER CHECK VALVE
VALVE CAP
SHIFT VALVE E
LOCK-UP SHIFT
VALVE