Changing The Output Status - YASKAWA NX100 Instructions Manual

8.16 Changing the Output Status

The status of external output signals can be changed from the programming pendant by using
either of the following two methods.
• On the user output status window
• On the RELAY ON window
The method that uses the RELAY ON window, which is described here, simplifies the opera-
tion for changing the status of signals that are used frequently.
A maximum of 32 output signals can be shown on the RELAY ON window and they must
NOTE
be set in advance to parameters S4C181 to S4C212. If they are not set, the sub menu in
the RELAY ON window will not be displayed.
Operation
1 Select {IN/OUT} under the
main menu.
2 Select {RELAY ON}.
3 Select the desired signal to
change the output status.
4 Press [INTERLOCK]
+[SELECT].
It is also possible to turn the relevant external output signal on only for the duration that
SUPPLE
[INTERLOCK]+[SELECT] are pressed. This selection is made in advance by setting the
-MENT
parameters (S4C213 to 244) to "1".
The RELAY ON window appears.
DATA EDIT
RELAY ON
OUTPUT NO. STATUS
OUT#0010
OUT#0012
OUT#0014
OUT#0016
OUT#0018
OUT#0015
OUT#0017
OUT#0019
Select the status ( or
The output status is changed. ( : status ON;
DATA EDIT
RELAY ON
OUTPUT NO. STATUS
OUT#0010
OUT#0012
OUT#0014
OUT#0016
OUT#0018
OUT#0015
OUT#0017
OUT#0019
8-101
8.16 Changing the Output Status
Explanation
DISPLAY UTILITY
NAME
[ ]
[ ]
[ ]
[ ]
[ ]
[ ]
[ ]
[ ]
) of the desired signal.
DISPLAY UTILITY
NAME
[ ]
[ ]
[ ]
[ ]
[ ]
[ ]
[ ]
[ ]
: status OFF.)