Configure Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
configure [memory | network | overwrite-network | terminal]
Use the configure command to enter the Global Configuration mode or to configure the system from
memory. Refer to Global Configuration Mode Command Set
Syntax Description
memory
network
overwrite-network
terminal
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 1.1
Usage Examples
The following example enters the Global Configuration mode from the Enable mode:
>enable
#configure terminal
(config)#
61200990L1-35E
Configures the active system with the commands located in the default
configuration file stored in NVRAM.
Configures the system from a TFTP network host.
Overwrites NVRAM memory from a TFTP network host.
Enters the Global Configuration mode.
Command was introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
on page 281 for more information.
82