Description Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
description <text>
Use the description command to identify the specified interface (for example, circuit ID, contact
information, etc.).
Syntax Description
<text>
Default Values
No defaults required for this command.
Applicable Command Modes
Applies to all interface mode command sets.
Applicable Platforms
Applies to all AOS products.
Command History
Release 1.1
Usage Examples
The following example enters comment information using the description command:
(config)#interface t1 1/1
(config-t1 1/1)#description This is the Dallas office T1
61200990L1-35E
Identifies the specified interface using up to 80 alphanumeric characters.
Command was introduced.
Copyright © 2005 ADTRAN
Common Commands
31