Clear Ip Igmp Group Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
clear ip igmp group [<group-address> | <interface>]
Use the clear ip igmp group command to clear entries from the Internet Group Management Protocol
(IGMP) tables. If no address or interface is specified, all non-static IGMP groups are cleared with this
command.
Syntax Description
<group-address>
<interface>
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, 4000, and 5000 and Total Access 900 Series
units.
Command History
Release 7.1
Release 9.1
Usage Examples
The following example shows output for the show igmp groups command before and after a
clear ip igmp group command is issued. This example clears the IGMP entry that was registered
dynamically by a host. Interfaces that are statically joined are not cleared:
#show ip igmp groups
IGMP Connected Group Membership
Group Address
Interface
Uptime
Expires
Last Reporter
172.0.1.50
Loopback100
01:22:59
00:02:46
172.23.23.1
172.1.1.1
Ethernet0/1
61200990L1-35E
Optional. Specifies the multicast IP address of the multicast group.
Optional. Designates the display of parameters for a specific interface (in the format
type slot/port). For example: eth 0/1.
Command was introduced.
Command was expanded to include HDSL and tunnel interfaces.
Copyright © 2005 ADTRAN
Enable Mode Command Set
54