Clear Ip Route Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
clear ip route [** | <ip address> <subnet mask>]
Use the clear ip route command to remove all learned routes from the IP route table. Static and connected
routes are not cleared by this command.
Syntax Description
**
<ip address>
<subnet mask>
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 1.1
Usage Examples
The following example removes all learned routes from the route table:
>enable
#clear ip route **
61200990L1-35E
Deletes all destination routes.
Specifies the IP address of the destination routes to be deleted.
Specifies the subnet mask of the destination routes to be deleted
Command was introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
61