Cross-Connect Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
cross-connect <#> <from interface> <slot/port> <tdm-group#>
<to interface> <slot/port>
Use the cross-connect command to create a cross-connect map from a created TDM group on an interface
to a virtual interface.
Changing cross-connect settings could potentially result in service interruption.
Syntax Description
<#>
<from interface>
<slot/port>
<tdm-group#>
<to interface>
<slot/port>
Default Values
By default, there are no configured cross-connects.
Applicable Platforms
Applies to all AOS products
Command History
Release 1.1
Release 5.1
Functional Notes
Cross-connects provide the mechanism for connecting a configured virtual (layer 2) endpoint with a
physical (layer 1) interface. Supported layer 2 protocols include Frame Relay and point-to-point protocol
(PPP).
61200990L1-35E
Identifies the cross-connect using a number descriptor or label for (useful in
systems that allow multiple cross-connects).
Specifies the interface (physical or virtual) on one end of the cross-connect. Enter
cross-connect 1 ? for a list of valid interfaces.
Used when a physical interface is specified in the <from interface> subcommand
(For example: specifying the T1 port of a T1 module would be t1 1/1).
Specifies which configured TDM group to use for this cross-connect. This
subcommand only applies to T1 physical interfaces.
Specifies the virtual interface on the other end of the cross-connect. Use the ? to
display a list of valid interfaces.
Used when a physical interface is specified in the <to interface> subcommand.
(For example, specifying the primary T1 port of a T1 module would be t1 1/1).
Command was introduced.
Command was expanded to include the E1 interface.
Copyright © 2005 ADTRAN
Common Commands
28