Enable Mode Command Set - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
E M
NABLE ODE
To activate the Enable mode, enter the enable command at the Basic mode prompt. (If an enable password
has been configured, a password prompt will display.) For example:
>enable
Password: XXXXXXX
#
The following command is common to multiple command sets and is covered in a centralized section of
this guide. For more information, refer to the section listed below:
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
clear commands begin on page 38
clock auto-correct-dst
clock no-auto-correct-dst
clock set <time> <day> <month> <year>
clock timezone <text>
configure [memory | network | overwrite-network | terminal]
copy <source> <destination>
copy console <filename>
copy flash <destination>
copy <filename> interface <interface> <slot/port>
copy tftp <destination>
copy xmodem <destination>
debug commands begin on page 89
dir on page 141
dir [<input> | flash | flash <input>]
disable on page 143
enable on page 144
erase [<filename> | startup-config]
events on page 146
exception report generate
logout on page 148
ping <address> on page 149
reload [cancel | in <delay>]
show commands begin on page 152
61200990L1-35E
C S
OMMAND ET
on page 76
on page 77
on page 78
on page 79
on page 83
on page 84
on page 85
on page 87
on page 88
on page 142
on page 145
on page 147
on page 151
Copyright © 2005 ADTRAN

Enable Mode Command Set

on page 82
on page 86
36