Renault Laguna III Manual page 2285

POWER ASSISTED STEERING
Power-assisted steering pump: Removal - Refitting
M9R, and 802 or 805 or 816, and LEFT-HAND DRIVE
a Fit a hose clamp (Ms. 583) on the low pressure pipe
between the reservoir and the power-assisted steer-
ing pump.
a Remove:
- the clip (5) using the (Mot. 1448),
- the low pressure pipe (6) from the power-assisted
steering pump.
a Fit a blanking plug.
a Remove:
- the high pressure pipe nut (7) ,
- the bolt securing the high pressure pipe bracket on
the oil filter unit,
- the pump high pressure pipe (8) from the power as-
sisted steering pump.
a Insert the blanking plugs.
a Remove:
- the bolts (9) from the power-assisted steering
pump,
- the power-assisted steering pump.
REFITTING
I - REFITTING PREPARATION OPERATION
a Always replace the high pressure pipe's O-ring.
a Before refitting the belt, clean the crankshaft pulley
V-grooves with a brush to remove any deposits.
112317
WARNING
Do not run the engine without the accessories
belt to avoid damaging the crankshaft accesso-
ries pulley.
II - REFITTING OPERATION FOR PART
CONCERNED
a
WARNING
Do not remove the blanking plugs from each
component until the last moment.
Also, do not remove the components from their
packaging until they are to be fitted to the vehi-
cle.
a Refit:
- the power steering pump,
112316
- the high-pressure pipe equipped with a new seal
on the power-assisted steering pump,
- the high pressure pipe brackets on the oil filter unit.
a Tighten to torque:
- the high pressure pipe union on the power-as-
sisted steering pump (23 N.m).
- the high pressure pipe bracket nut (8 N.m),
- the high pressure pipe bracket bolt on the oil fil-
ter unit (8 N.m).
a Refit the low pressure pipe on the power-assisted
steering pump.
36B-6
36B