Renault Laguna III Manual page 2258

Steering box: Removal - Refitting
- the steering box.
REFITTING
I - REFITTING PREPARATION OPERATION
a Always replace:
- the steering box nuts,
- the subframe bolts,
- the track rod nuts,
- the anti-roll bar tie-rod nuts,
- the lower ball joint nut,
- the universal joint nut and bolt,
- the power-assisted steering pipe O-rings.
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit:
- the steering box,
- the steering box nuts.
a Torque tighten the steering box nuts (180 N.m).
LEFT-HAND DRIVE
a Refit:
- the heat shield,
- the heat shield bolts.
III - FINAL OPERATION
a Refit:
- the front axle sub-frame (see 31A, Front axle
components, Front axle subframe: Removal -
Refitting, page 31A-58) ,
- the front and side wheel arch liners (see Front
wheel arch liner: Removal - Refitting) (55A, Ex-
terior protection),
- the engine undertray,
- the front wheels (see 35A, Wheels and tyres,
Wheel: Removal - Refitting, page 35A-1) .
a Check the axle geometry (see 30A, General infor-
mation, Axle assemblies: Check, page 30A-19) .
a Adjust the front axle, if necessary (see 30A, General
information, Front axle system: Adjustment,
page 30A-28) .
STEERING ASSEMBLY
4-WHEEL STEERING
a Adjust the rear axle, if necessary (see 30A, General
information, Rear axle system: Adjustment, page
30A-32) .
36A-7
36A