Renault Laguna III Manual page 2270

Steering column: Removal - Refitting
LEFT-HAND DRIVE
II - REFITTING OPERATION FOR PART
CONCERNED
a Mount the steering column.
a Clip the wiring harness onto the steering column.
a Connect the connector to the electric steering col-
umn lock.
a Screw without tightening the steering column nuts.
a Observe the direction of fitting for the universal joint
cam nut.
a Fit the universal joint.
a Refit the universal joint cam nut and bolt.
a Offer up the universal joint cam nut and bolt.
a Lock the cam nut in its housing (on the universal
joint).
a Pretighten the universal joint bolt.
a Check that the universal joint is in the correct posi-
tion.
a Tighten to torque:
- the steering universal joint stud (24 Nm),
STEERING ASSEMBLY
101354
116022
- the steering column nuts (21 Nm).
a Clip the steering gaiter on the front bulkhead.
III - FINAL OPERATION.
a Refit:
- the engine undertray,
- the engine undertray bolts,
- the dashboard lower trim (see Dashboard lower
trim: Removal - Refitting) (MR 416, 57A, Interior
equipment),
- the steering column switch assembly (see Steer-
ing column switch assembly: Removal - Refit-
ting) (MR 415, 84A, Control - Signals),
- the steering wheel (see 36A, Steering assembly,
Steering wheel: Removal - Refitting, page 36A-
27) ,
- the driver's front airbag (see Driver's frontal air-
bag: Removal - Refitting) (MR 415, 88C, Airbags
and seat belt pretensioners).
a Connect the battery (see Battery: Removal - Refit-
ting) (MR 415, 80A, Battery).
Note:
it is necessary to unlock the airbag computer in
order to lock the steering column.
a Apply the after repair procedure using the Diagnos-
tic tool :
- connect the Diagnostic tool,
- select the airbag computer,
- go to repair mode,
- apply the "After repair procedure".
36A-19
36A