Renault Laguna III Manual page 2293

POWER ASSISTED STEERING
Power-assisted steering pump: Removal - Refitting
D91, and V4Y
a Remove the accessories belt adjustment bolt (3) .
a Remove:
- the power-assisted steering pump bolt (4) ,
- the power-assisted steering pump.
REFITTING
I - REFITTING PREPARATION OPERATION
a parts always to be replaced: Power-assisted
steering pipe seal (13,04,04,22)
a Before refitting the accessories belt, clean the V-
grooves of the crankshaft pulley with a brush to re-
move any deposits.
WARNING
Do not run the engine without the accessories
belt to avoid damaging the crankshaft accesso-
ries pulley.
II - REFITTING OPERATION FOR PART
CONCERNED
a
WARNING
Do not remove the blanking plugs from each
component until the last moment.
Also, do not remove the components from their
packaging until they are to be fitted to the vehi-
135361 cle.
a Refit:
- the power-assisted steering pump,
- the high-pressure pipe equipped with a new seal
on the power-assisted steering pump,
- the low pressure pipe on the power-assisted steer-
ing pump.
a Torque tighten the high pressure pipe union on
the power-assisted steering pump (21 N.m).
a Remove the tool (Ms. 583).
III - FINAL OPERATION
a Refit:
- the accessories belt (see Accessories belt: Re-
moval - Refitting) (11A, Top and front of engine),
- the front right-hand wheel arch liner (see Front
wheel arch liner: Removal - Refitting) (55A, Ex-
terior protection),
135272
- the front right-hand wheel (see 35A, Wheels and
tyres, Wheel: Removal - Refitting, page 35A-1) .
a Bleed the power-assisted steering circuit (see 36B,
Power assisted steering, Power-assisted steer-
ing circuit: Bleeding, page 36B-54) .
a Check that there are no leaks.
a Refit:
- the engine undertray,
- the engine cover.
36B-14
36B