Show Ip Ospf Neighbor - Dell S4810 Reference Manual

Item
Neighbor Count...
Example
Dell>show ip ospf int
GigabitEthernet 13/17 is up, line protocol is up
BROADCAST, Cost: 1
192.168.1.2
address 192.168.1.1
Retransmit 5
Router)
GigabitEthernet 13/23 is up, line protocol is up
BROADCAST, Cost: 1
192.168.0.4
address 192.168.0.2
Retransmit 5
Router)
Loopback 0 is up, line protocol is up
LOOPBACK, Cost: 1
Loopback interface is treated as a stub Host.
Dell>

show ip ospf neighbor

Display the OSPF neighbors connected to the local router.
S4810
Syntax
show ip ospf [process-id | vrf vrf-name] neighbor
Parameters
process-id
1224
Description
This line displays the number of neighbors and adjacent
neighbors. Listed below this line are the details about each
adjacent neighbor.
Internet Address 192.168.1.2/30, Area 0.0.0.1
Process ID 1, Router ID 192.168.253.2, Network Type
Transmit Delay is 1 sec, State DR, Priority 1
Designated Router (ID) 192.168.253.2, Interface address
Backup Designated Router (ID) 192.168.253.1, Interface
Timer intervals configured, Hello 10, Dead 40, Wait 40,
Hello due in 00:00:02
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor 192.168.253.1 (Backup Designated
Internet Address 192.168.0.1/24, Area 0.0.0.1
Process ID 1, Router ID 192.168.253.2, Network Type
Transmit Delay is 1 sec, State DROTHER, Priority 1
Designated Router (ID) 192.168.253.5, Interface address
Backup Designated Router (ID) 192.168.253.3, Interface
Timer intervals configured, Hello 10, Dead 40, Wait 40,
Hello due in 00:00:08
Neighbor Count is 3, Adjacent neighbor count is 2
Adjacent with neighbor 192.168.253.5 (Designated Router)
Adjacent with neighbor 192.168.253.3 (Backup Designated
Internet Address 192.168.253.2/32, Area 0.0.0.1
Process ID 1, Router ID 192.168.253.2, Network Type
Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first
OSPF process.
Open Shortest Path First (OSPFv2 and OSPFv3)