Port-Based Vlan Configuration Commands; Display Port; Port - H3C S3100 Series Command Manual

Hide thumbs Also See for S3100 Series:

Table of Contents

The above output information indicates that VLAN 7 (the voice VLAN) cannot be removed, while the

other VLANs are removed successfully.

Port-Based VLAN Configuration Commands

display port { hybrid | trunk }

hybrid: Displays hybrid ports.

trunk: Displays trunk ports.

Use the display port command to display the existing hybrid or trunk ports, if any.

For information about port type configuration, refer to the

# Display the existing hybrid ports.

<Sysname> display port hybrid

The following hybrid ports exist:

Ethernet1/0/1

The above information shows the current system has two hybrid ports: Ethernet 1/0/1 and Ethernet

port interface-list

undo port interface-list

interface-list: List of the Ethernet ports to be added to or removed from the current VLAN. In this list, you

can specify individual ports and port ranges. An individual port takes the form of interface-type

interface-number and a port range takes the form of interface-type interface-number1 to interface-type

interface-number2, with interface-number2 taking a value no less than interface-number1. The total

number of individual ports and port ranges defined in the list must not exceed 10.

Use the port command to assign one or multiple access ports to the current VLAN.

Use the undo port command to remove the specified access port(s) from the current VLAN.

Ethernet1/0/2

port link-type

Table of Contents