Port-Based Vlan Configuration Commands; Display Port; Port - H3C s3600 series Command Manual

Port-Based VLAN Configuration Commands

display port

Syntax
display port { hybrid | trunk }
View
Any view
Parameters
hybrid: Displays hybrid ports.
trunk: Displays trunk ports.
Description
Use the display port command to display the existing hybrid or trunk ports, if any.
For information about port type configuration, refer to the
Examples
# Display the existing hybrid ports.
<Sysname> display port hybrid
The following hybrid ports exist:
Ethernet1/0/1
The above information shows the current system has two hybrid ports: Ethernet 1/0/1 and Ethernet
1/0/2.

port

Syntax
port interface-list
undo port interface-list
View
VLAN view
Parameters
interface-list: List of the Ethernet ports to be added to or removed from the current VLAN. In this list, you
can specify individual ports and port ranges. An individual port takes the form of interface-type
interface-number and a port range takes the form of interface-type interface-number1 to interface-type
interface-number2, with interface-number2 taking a value no less than interface-number1. The total
number of individual ports and port ranges defined in the list must not exceed 10.
Description
Use the port command to assign one or multiple access ports to the current VLAN.
Use the undo port command to remove the specified access port(s) from the current VLAN.
Ethernet1/0/2
1-9
port link-type command.