Status Interface; Status Ip-Board - Avaya DEFINITY Server CSI Maintenance Manual

status interface

status interface
Use status interface to display the number of counters maintained by the PI (a
front end processor implementing packet layers and link layers of the BX.25
protocol and the ISDN procedure-D protocols).
Action/Object Qualifier
status location
interface
print
Output
The following example shows the output from status interface a1.
status interface a1
Base Level Occupancy(low): 10
Base Level Occupancy(high): 25
Primary Queue Audit Error: 4
Secondary Queue Audit Error: 10
Translation Audit Error: 12
Protocol Timer Audit Error: 0
Hardware Sanity Timeout: 1
Hardware Resource Error: 12
Hardware Overload Error: 8

status ip-board

status ip-board CCcss
The status ip-board command runs on R9 and higher systems. The command
has the same syntax and output as the status c-lan-ip command except the list of
allowed boards is larger. The command can be run on either a TN799 or a
TN2302.
NOTE:
This SAT command cannot be run on the MAPD circuit pack, although
similar commands can be carried out through the MAPD's operating system.
The status ip-board CCcss command returns the data shown in the first two
columns of the
last hour start time and end time for the error counter statistics.
555-233-119
Qualifier Description
Location of processor interface (PI)
board: (cabinet-carrier-position)
1 = first processor interface
2 = second processor interface
Report sent to printer
PROCESSOR INTERFACE STATUS
Table 27. The form also shows the time of the last port reset, the
Feature
Logins Default Interactions
init 1 (one) none
inads
craft
cust
rcust
bcms
browse
Issue 5 October 2002
483