status conference
Is the endpoint participating in the conference or connecting to the
In Use
conference? - y, c, e, f, n, blank.
y = The endpoint is in use and fully-connected on all media in an
active conference.
c = The endpoint is in use and fully-connected; however, the
endpoint changes the conference audio or video capability, or the
rate of the conference due to rate adaptation. This condition requires
analysis of this endpoint's capabilities and mode fields to identify the
reduced capability.
e = The endpoint active, but has capability problems. The endpoint
lacks one of the required capabilities (Vid, Bhl, MLP) to be a full
participant. For MLP capabilities, see the "T120" field. This condition
requires analysis of this endpoint's capabilities and mode field to
identify the missing capability.
f = The endpoint is active, but is not connected to all media. The
endpoint declared all required capabilities (channel/video/
audio/data) but is not fully-connected to all conference media. This
endpoint may be connecting, failed to connect, or is not a valid video
source. This condition requires analysis of this endpoint's capabilities
and mode fields to identify the problem.
n = The endpoint connects then disconnects in a conference, or
unsuccessfully attempts to connect to a conference.
"blank" = Blank until the first call is made from or to the endpoint.
Enhanced Basic Service Flag - n, y
Enh BAS
y = The endpoint supports the enhanced BAS commands/caps;
n = The endpoint supports the basic BAS commands/caps.
Data on the quantify and quality of channels (transfer rate)? - y, e, n,
Chl
blank
y = The endpoint has the required number of channels.
e = The endpoint does not declare support for the correct number of
channels and cannot participate fully in the conference.
n = The endpoint declares the correct number of channels, but not all
channels join the conference, due to network or endpoint problems.
"blank" = Audio add-on endpoints set the Chl field to blank.
555-233-119
Issue 5 October 2002
451
Need help?
Do you have a question about the DEFINITY Server CSI and is the answer not in the manual?
Questions and answers