Configuring Ospf (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING J SERIES SERVICES ROUTERS AND SRX SERIES SERVICES GATEWAYS GUIDE REV Manual

Configuring OSPF (NSM Procedure)

Table 65: OSPF Configuration Fields
Option
OSPF
Copyright © 2010, Juniper Networks, Inc.
Chapter 11: Configuring Protocols for J Series Services Routers and SRX Series Services Gateways
OSPF uses the shortest path first (SPF) algorithm to determine the route to reach each
destination. All devices in an area run this algorithm in parallel, storing the results in their
individual topological databases. Devices with interfaces to multiple areas run multiple
copies of the algorithm.
To configure OSPF in NSM:
In the navigation tree select
1.
In the list, double click the device to select it.
Devices
2.
Click the Configuration
3.
In the configuration tree, expand
4.
Add/Modify the parameters under the respective tabs as specified in Table 65 on
5.
page 111.
Click one:
6.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply — To apply the protocol settings.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See Updating
Devices for more information.
Function
Device Manager > Devices
tab.
and select
Protocols
Your Action
.
.
OSPF
111