Takeover - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

Hide thumbs Also See for OmniSwitch 6250:

Table of Contents

CMM Commands

takeover

The current secondary CMM assumes the role of primary CMM.

takeover [with-fabric]

Syntax Definitions

Platforms Supported

OmniSwitch 6250

Usage Guidelines

This command causes the secondary CMM to take over the functions of the primary CMM. After this

command, the old primary CMM is the new secondary CMM.

Before issuing the takeover command, be sure that the secondary CMM has all software (i.e., image

and configuration files) required to continue CMM operations.

For information on synchronizing the primary and secondary CMM software before issuing the

takeover command, see the

When the CMM modules switch primary and secondary roles, the console session to the new primary

CMM is disconnected. To continue managing the switch, be sure that you have physical connections to

both CMMs or local access to the switch in order to move your Ethernet or serial cable from one CMM

to the other.

This command can also be used on the secondary CMM.

If the switch is part of an a stackable configuration consisting of three or more switches, the next

switch in "idle" mode becomes the secondary CMM, and the original primary CMM becomes "idle."

For more information on stacks, see "Managing Stacks" in the Hardware Users Guide.

Note. The saved boot.cfg file will be overwritten if the takeover command is executed after the

running-config working

Refer to the

"NIs Reload On Takeover"

command and redundant management modules.

-> takeover with-fabric

OmniSwitch 6250 CLI Reference Guide

Performs a complete CMM reload.

copy flash-synchro

write memory

commands, in an OmniSwitch set up with redundant CMMs.

description on

November 2009

for more information on the takeover