Display Vendor-Specific Information - 3Com S7906E Command Reference Manual

If no parameter is specified, the information about all the protocols that the ONU supports is displayed.
This command takes effect on H3C ONUs only.
STP runs normally only when all attached ONUs are H3C ONUs.
Examples
# Display the information about IGMP snooping supported by the ONU.
<Sysname> system-view
[Sysname] interface onu 3/0/1:1
[Sysname-Onu3/0/1:1] display onu-protocol igmp-snooping
Protocol name: IGMP snooping
Protocol status: enabled
Multicast Address
1 01:00:5e:01:01:01
2 01:00:5e:01:01:02
Table 2-3 display onu-protocol igmp-snooping command output description
Protocol name: IGMP snooping
Protocol status: enabled
Multicast Address
UNI Port
VLAN

display vendor-specific information

Syntax
display vendor-specific information
View
ONU port view
Default Level
1: Monitor level
Parameters
None
UNI Port VLAN
2
3
Field
10
20
Protocol name
Protocol status: enabled or disabled
Multicast MAC address
UNI port number
Multicast VLAN number
2-7
Description