Stp No-Agreement-Check - 3Com S7906E Command Reference Manual

mstp: Configures an MSTP-enabled device to work in MSTP mode.
Description
Use the stp mode command to configure the MSTP work mode of the device.
Use the undo stp mode command to restore the MSTP work mode to the default setting.
By default, an MSTP-enabled device works in MSTP mode.
Related commands: stp mcheck, stp.
Examples
# Configure the MSTP-enabled device to work in STP-compatible mode.
<Sysname> system-view
[Sysname] stp mode stp

stp no-agreement-check

Syntax
stp no-agreement-check
undo stp no-agreement-check
View
Ethernet port view, port group view, Layer-2 aggregate port view
Default Level
2: System level
Parameters
None
Description
Use the stp no-agreement-check command to enable No Agreement Check on the port(s).
Use the undo stp no-agreement-check command to disable No Agreement Check on the port(s).
By default, No Agreement Check is disabled.
Note that:
Configured in port view, the setting takes effect on the current port only; configured in port group
view, the setting takes effect on all ports in the port group.
Configured in Layer-2 aggregate port view, the setting takes effect only on the aggregate port.
Configured on the member port in an aggregation group, the setting can take effect only after the
port leaves the aggregation group. For detailed information about link aggregation, refer to Link
Aggregation Configuration in the Access Volume.
1-23