Alarm Llid-Mismatch Threshold - 3Com S7906E Command Reference Manual

6300 series
Hide thumbs Also See for S7906E:
Table of Contents

Advertisement

Default Level
2: System level
Parameters
None
Description
Use the alarm llid-mismatch enable command to enable the LLID mismatch frame alarm.
Use the undo alarm llid-mismatch enable command to disable the LLID mismatch frame alarm.
By default, the LLID mismatch frame alarm is disabled.
Examples
# Enable the LLID mismatch frame alarm on OLT 3/0/1.
<Sysname> system-view
[Sysname] interface olt 3/0/1
[Sysname-Olt3/0/1] alarm llid-mismatch enable

alarm llid-mismatch threshold

Syntax
alarm llid-mismatch threshold threshold
undo alarm llid-mismatch threshold
View
OLT port view, FTTH view
Default Level
2: System level
Parameters
threshold threshold: Specifies the alarm threshold of the LLID mismatch frame alarm. It ranges from
9
1000 to 10
frames and defaults to 5000 frames.
Description
Use the alarm llid-mismatch threshold command to configure the alarm threshold of LLID mismatch
frame.
Use the undo alarm llid-mismatch threshold command to restore the default alarm threshold.
The system generates an LLID mismatch frame alarm when the timeslots are used in disorder, that is,
one ONU uses another ONU's timeslot to forward data.
Related commands: alarm llid-mismatch enable.
Examples
# Set the alarm threshold of LLID mismatch frame to 6000 frames.
<Sysname> system-view
[Sysname] interface olt 1/0/1
3-5

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

S7910eS7906e-vS7903eS7903e-sS7902e

Table of Contents