Onu-Event - 3Com S7906E Command Reference Manual

Description
Use the multicast-mode command to configure the multicast mode of the ONU.
Use the undo multicast-mode command to restore the default.
By default, the multicast mode of the ONU is IGMP Snooping.
Examples
# Configure the multicast mode of the ONU as the multicast control mode.
<Sysname> system-view
[Sysname] interface onu 3/0/1:1
[Sysname-Onu3/0/1:1] multicast-mode multicast-control

onu-event

Syntax
onu-event { debug | log | trap } enable level severity
undo onu-event { debug | log | trap }
View
ONU port view
Parameters
debug: Displays the types of debugging information allowed to be output by the ONU on the OLT.
log: Displays the log information generated by the ONU on the OLT.
trap: Displays the trap information generated by the OLT on the ONU.
severity: Severity level of the information that the ONU reports to the OLT. The severity levels include (in
the descending order of priority):
emergencies, alerts, critical, errors, warnings, notifications, information, and debugging.
Description
Use the onu-event { debug | log | trap } enable level command to specify the ONU to report log,
debugging, or trap information to the OLT.
Use the undo onu-event { debug | log | trap } command to restore the default.
By default, an ONU reports no information to the OLT.
Note that: because a large number of ONUs are attached to an OLT, enabling ONUs to report
information to the OLT may generate a large amount of traffic and thus cause congestion. Therefore,
you are recommended to select the reported information types as required.
Examples
# Configure the OLT attached to ONU 3/0/1:1 to report log information with severity levels higher than
errors.
<Sysname> system-view
[Sysname] interface onu 3/0/1:1
[Sysname-Onu3/0/1:1] onu-event log enable level ?
alerts <=ALERT level messages to OLT (severity=1)
2-19