Alarm Oam Local-Link-Fault Enable; Alarm Oam-Vendor-Specific Enable - 3Com S7906E Command Reference Manual

The commands here take effect only for OAM 2.0 and above.
Examples
# Enable the error frame seconds summary alarm for the ONU corresponding to ONU 3/0/1:1.
<Sysname> system-view
[Sysname] interface onu 3/0/1:1
[Sysname-Onu3/0/1:1] alarm oam error-frame-seconds-summary enable

alarm oam local-link-fault enable

Syntax
alarm oam local-link-fault enable
undo alarm oam local-link-fault enable
View
OLT port view, FTTH view
Default Level
2: System level
Parameters
None
Description
Use the alarm oam local-link-fault enable command to enable the local link fault alarm.
Use the undo alarm oam local-link-fault enable command to disable the local link fault alarm.
By default, the local ink fault alarm is enabled.
The system generates a local link fault alarm when the receiving direction of the local data terminal is in
trouble.
Examples
# Enable the local link fault alarm on OLT 3/0/1.
<Sysname> system-view
[Sysname] interface olt 3/0/1
[Sysname-Olt3/0/1] alarm oam local-link-fault enable

alarm oam-vendor-specific enable

Syntax
alarm oam-vendor-specific enable
undo alarm oam-vendor-specific enable
3-15