Uni Flow-Control - 3Com S7906E Command Reference Manual

Default Level
2: System level
Parameters
uni-number: UNI number, in the range 1 to the number of UNI ports of the current ONU. The number of
UNIs can be up to 80.
full: Specifies the port to be in full duplex mode.
half: Specifies the port to be in half duplex mode.
auto: Specifies the duplex mode of the port to be auto-negotiation.
Description
Use the uni duplex command to set the duplex mode for UNIs.
Use the undo uni duplex command to restore the duplex mode on the current port to the default value.
By default, the duplex mode on UNIs is full.
This command takes effect on H3C ONUs only.
Examples
# Configure UNI 1 to operate in the auto-negotiation mode.
<Sysname> system-view
[Sysname] interface onu 3/0/1:1
[Sysname-Onu3/0/1:1] uni 1 duplex auto

uni flow-control

Syntax
uni uni-number flow-control
undo uni uni-number flow-control
View
ONU port view
Default Level
2: System level
Parameters
uni-number: UNI number, in the range 1 to the number of UNI ports of the current ONU. The number of
UNIs can be up to 80.
2-29