Revision-Level - 3Com S7906E Command Reference Manual

Description
Use the reset stp command to clear the MSTP statistics information.
The MSTP statistics information includes the numbers of TCN BPDUs, configuration BPDUs, RST
BPDUs and MST BPDUs sent/received through the specified port(s) (STP BPDUs and TCN BPDUs are
counted only for the CIST).
Note that this command clears the spanning tree-related statistics information on the specified port(s) if
you specify the interface-list argument; otherwise, this command clears the spanning tree-related
statistics on all ports.
Related commands: display stp.
Examples
# Clear the spanning tree-related statistics information on ports GigabitEthernet 2/0/1 through
GigabitEthernet 2/0/3.
<Sysname> reset stp interface GigabitEthernet 2/0/1 to GigabitEthernet 2/0/3

revision-level

Syntax
revision-level level
undo revision-level
View
MST region view
Default Level
2: System level
Parameters
level: MSTP revision level, in the range of 0 to 65535. The system default is 0.
Description
Use the region-level command to configure the MSTP revision level of your device.
Use the undo region-level command to restore the default MSTP revision level.
The MSTP revision level, the MST region name and the VLAN-to-MSTI mapping table of a device jointly
determine the MST region the device belongs to.
Related commands: instance, region-name, check region-configuration, vlan-mapping modulo,
active region-configuration.
Examples
# Set the MSTP revision level of the MST region to 5.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] revision-level 5
1-13