3.4 Keypad Operation
9.
When the keypad shows this screen after Auto-Tuning is complete for 1 or 2 minutes, push
The keypad will show a list of the changed parameters as the result of Auto-Tuning.
10.
Push
or
[Auto-Tuning Successful] at the bottom of the screen and push
To change a parameter again, push
parameter setting screen.
Auto-Tuning is complete.
Note:
If the drive detects an error or you push
code. Endx identifies that Auto-Tuning was successful with calculation errors. Find and repair the cause of the error and do Auto-Tuning
again, or set the motor parameters manually. You can use the drive in the application if you cannot find the cause of the Endx error. Er-xx
identifies that Auto-Tuning was not successful. Find and repair the cause of the error and do Auto-Tuning again.
◆
Set the Keypad Language Display
The procedure in this section shows how to set the language shown on the keypad.
1.
Push
(Home) to show the HOME screen.
Note:
• The keypad will show [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on
2.
Push
(Menu).
576
in the parameter change confirmation screen to check the changed parameters, then select
or
before Auto-Tuning is complete, Auto-Tuning will stop and the keypad will show an error
, push
(Back), to show [Home] on
.
to select the parameter to change, then push
.
YASKAWA TOEPYAIGA8002B GA800 Drive Programming
or
.
to show the