Advertisement
4
Keypad Operation
LED Operator and Keys
The LED operator is used to program the drive, to start/stop it, and to display fault information. The LEDs indicate the drive status.
Keys and Functions
Display
Data Display Area
ESC Key
RESET Key
RUN Key
RUN
Up Arrow Key
Down Arrow Key
STOP Key
STOP
ENTER Key
LO/RE Selection Key
ALM LED Light
ALM
REV LED Light
REV
DRV LED Light
DRV
FOUT LED Light
FOUT
LO/RE LED Light
LO
RE
/
YASKAWA Europe TOEP C710606 75B - AC Drive V1000 IP66 - Quick Start Guide
Name
Displays the frequency reference, parameter number, etc.
Returns to the previous menu.
Moves the cursor to the right.
Resets a fault.
Starts the drive in the LOCAL mode. The Run LED
is on, when the drive is operating the motor.
flashes during deceleration to stop or when the frequency reference is 0.
Scrolls up to select parameter numbers, setting values, etc.
Scrolls down to select parameter numbers, setting values, etc.
Stops the drive in the LOCAL mode. The Stop LED
• is on when the drive is not operating the motor.
• flashes during deceleration at a fast-stop or stop by interlock operation.
• is off during run, deceleration to stop, or when the frequency reference is 0.
Selects modes, parameters and is used to store settings.
Switches drive control between the operator (LOCAL) and the control circuit terminals (REMOTE).
Flashing: The drive is in an alarm state.
On: The drive is in a fault state and the output is stopped.
On: The motor rotation direction is reverse.
Off: The motor rotation direction is forward.
On: The drive is ready to operate the motor.
Off: The drive is in the Verify, Setup, Parameter Setting or Auto tuning mode.
On: The output frequency is displayed on the data screen.
Off: Anything else than the output frequency is displayed on the data screen.
On: The drive is in the LOCAL mode.
Off: The drive is in the REMOTE mode.
STOP
RUN
Function
4 Keypad Operation
EN 17
Advertisement
