Change Fiber-Link - Avaya S8700 Maintenance Manual

change fiber-link

change fiber-link
change fiber-link fiber#
NOTE:
This command is not valid for S8700 IP Connect configurations.
The change fiber-link command changes the translation data associated with an
existing fiber link. On critical-reliability systems (duplicated PNC), each fiber link
is duplicated and exists as a pair. When PNC duplication is enabled, only the
fields on pages 2 and 3 (the DS1 CONV complex attributes) can be changed.
Translation data is not changed until the
any time before pressing E
line without changing any translation data.
When you enter a command that changes translation data, two checks are made:
You must have permission to administer the feature.
No other user may be executing a change, add , or remove fiber-link
command.
To change the endpoint board locations, you must remove a fiber and add it again
for either a:
High-reliability system (unduplicated PNC)
Critical-reliability system with a fully operational duplicated PNC
Parameters
number The administered number (1–44) associated with a fiber link or, on a duplicated PNC,
with a fiber link pair.
Examples
change fiber-link 21
555-233-143
key is pressed. Pressing
Enter
to enter the changes returns you to the command
NTER
CANCEL
Issue 1 May 2002 7-61