Avaya DEFINITY Server CSI Maintenance Manual page 1821

UDS1-BD (UDS1 Interface Circuit Pack)
Translation Update Test (#146)
The Translation Update Test sends the circuit-pack-level information specified by
System Administration to the UDS1 Interface circuit pack. Translation includes the
following data administered for a UDS1 Interface circuit pack (see output of
display ds1 UUCSS command): DS1 Link Length between two DS1 endpoints,
Synchronization Source Control, All Zero Suppression, Framing Mode, Signaling
Mode, Time Slot Number of 697-Hz Tone, Time Slot Number of 700-Hz Tone, etc.
In G3V3, if a TN464F or later UDS1 circuit pack is combined with a 120A1 CSU
Module or the 401A T1 Sync Splitter to form an Integrated CSU Module/T1 Sync
Splitter, this test will also send the administration for this Integrated CSU to the
circuit pack to assure the board's translations are correct. The administration of
the CSU Module/T1 Sync Splitter is done using the DS1 Circuit Pack
administration form. Translation for the CSU Module/T1 Sync Splitter includes the
following data: Transmit LBO, Receive ALBO, Supply CPE Loopback Jack
Power?, etc.
Table 538. TEST #146 Translation Update Test
Error Test
Code Result
ABORT
FAIL
555-233-119
Description/ Recommendation
Internal system error
1. Retry the command at 1-minute interval s a maximum of 5 times.
Internal system software error.
1. Enter the display ds1 UUCSS command to verify the UDS1 Interface
circuit pack translation.
Continued on next page
Issue 5 October 2002
1821