Avaya DEFINITY Server CSI Maintenance Manual page 1866

Maintenance Objects
Circuit Pack Restart Test (#594)
NOTE:
This test is destructive.
Execute this test (not part of either short or long demand test sequence) to reset
the circuit pack only if there are PPCPU errors. This test fails if the circuit pack
does not return to a sane state after being reset. The circuit pack resets through
the SAKI Sanity Test (#53).
Table 551. Test #594 Circuit Pack Restart Test
Error Test
Code Result
None ABORT
1015 ABORT
1966 ABORT
2100 ABORT
1, 2 FAIL
PASS
1866
Issue 5 October 2002
Description/ Recommendation
Could not allocate the necessary system resources to run test.
Retry the command at 1-minute intervals, up to 5 times.
If the problem persists, escalate the problem.
Port is not out-of-service.
Busyout the circuit pack (busyout board UUCSS).
Retry the command at 1-minute intervals, up to 5 times.
If the problem persists, escalate the problem.
The board is in the process of running the autosave command to save
announcements.
Retry the command again later.
Could not allocate the necessary system resources to run test.
Retry the command at 1-minute intervals, up to 5 times.
If the problem persists, escalate the problem.
The circuit pack failed to reset.
Retry command at 1-minute intervals, up to 5 times.
If the problem persists, pull out and reseat the circuit pack.
If the problem persists, replace the circuit pack.
The circuit pack initialized correctly.
Continued on next page