Other Hardware - Avaya DEFINITY Server CSI Maintenance Manual

VAL-BD (Voice Announcements over LAN Circuit Pack)
Table 558. TN2501AP LEDs
LED Behavior
Red On solid
Green On solid
Amber On solid
Amber Fast flash
(100ms on/
100ms off)
Amber Slow flash
(200ms on/
200ms off)
LINK On/off
TRMT Intermittent
RCV Intermittent
100M On/off
FDX On/off
COL On/off

Other hardware

To establish LAN connections the TN2501AP circuit pack requires a
Backplane Adapter that attaches to the Amphenol connector on the back of
the cabinet, corresponding to the TN2501AP integrated announcement
circuit pack slot.
LAN cable
555-233-119
Description
Circuit pack failure or a major or minor on-board alarm
Firmware is self-downloading to the circuit pack or testing in
progress.
Firmware is self-downloading to the circuit pack.
!
CAUTION:
You can lose the resident firmware image file if you reset the
circuit pack during firmware download. If this happens, FTP a
new firmware image file to the VAL circuit pack and perform
the Firmware download procedure again.
Occurs during circuit pack insertion or circuit pack reset which the
announcement files are being copied from FLASH to RAM. If you
reset the circuit pack during this time, your announcement files
remain intact.
Flashes during autosave while copying announcement files from
RAM to FLASH.
!
CAUTION:
You can lose the announcements on the circuit pack if you
reset it during an autosave.
Active ethernet link
Transmit
Receive
Off = 10MB ethernet connection
On = 100MB ethernet connection
Off = half-duplex connection
On = full duplex connection
Off = no collision detected
On = collisions detected
that attaches to the Backplane Adapter.
Continued on next page
Issue 5 October 2002
1875