Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual page 1387

Options
Mode
Copyright © 2010, Juniper Networks, Inc.
ipAddress1—IP address of the interface on the remote router
hostname—Name of the host to serve as the tunnel endpoint
ipAddress2—IP address of the tunnel destination address subnet
mask—IP mask of the tunnel destination address subnet
ipAddressLow—First IP address in a destination address range
ipAddressHigh—Last IP address in a destination address range
ipAddress3—IP address of the interface on the remote router or the router ID of the
destination router that serves as the tunnel endpoint
fqdn—Fully qualified domain name of the interface on the remote router that serves
as the tunnel endpoint; a maximum of 80 characters
isis-level-2—Specifies IS-IS level-2 routers as acceptable destinations
ospf-bdr—Specifies OSPF border routers as acceptable destinations
listName—Name of access list or prefix list that contains the IP addresses that are
acceptable as tunnel endpoints
ipAddress4—IP address of the interface on the remote router or the router ID of the
destination router that serves as the tunnel endpoint; for a tunnel profile, you can list
multiple addresses
*—Indicates that one or more parameters can be repeated multiple times in a list in
the command line
Interface Configuration, IP Tunnel Destination Profile Configuration, Tunnel Profile
Configuration
Chapter 8: T Commands
1345