Svlan Ethertype - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

svlan ethertype

Syntax
Release Information
Description
Options
Mode
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
svlan ethertype ethertypeValue
no svlan ethertype
Command introduced before JunosE Release 7.1.0.
88a8 keyword added in JunosE Release 7.1.0.
In Interface Configuration mode, specifies the Ethertype of an S-VLAN. The no version
restores the default value, 9100.
In Profile Configuration mode, specifies the available Ethertypes that the packet must
use to create a dynamic VLAN subinterface. The no version restores the default value,
autoconfig.
ethertypeValue—One of the following Ethertype values:
8100—Specifies Ethertype value 0x8100, as defined in IEEE Standard 802.1q
88a8—Specifies Ethertype value 0x88a8, as defined in draft IEEE Standard 802.1ad
9100—Specifies Ethertype value 0x9100, which is the default for Interface
Configuration mode
autoconfig—Specifies in a VLAN profile that the packet can use any Ethertype to
create a dynamic VLAN subinterface; this is the default for Profile Configuration
mode
Interface Configuration, Profile Configuration
Configuring S-VLAN Tunnels for Layer 2 Services in the JunosE BGP and MPLS
Configuration Guide
Chapter 7: S Commands
1249