Single-Shot-Tunnel - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide N to Z

single-shot-tunnel

Syntax
Release Information
Description
Mode
1178
[ no ] single-shot-tunnel
Command introduced in JunosE Release 7.2.0.
Configures the L2TP/IPSec tunnels associated with a particular L2TP host profile as
single-shot tunnels. The underlying IPSec connection for a single-shot tunnel can carry
no more than a single L2TP tunnel for the duration of its existence, and the L2TP tunnel
can carry no more than a single L2TP session for the duration of its existence. The no
version restores the default behavior for L2TP/IPSec tunnels, which disables the
single-shot attribute.
NOTE: Although configuration of single-shot tunnels is more typically used
with secure L2TP/IPSec tunnels, you can also configure single-shot tunnels
for nonsecure L2TP tunnels that do not run over an IPSec transport
connection.
L2TP Destination Profile Host Configuration
Copyright © 2010, Juniper Networks, Inc.