Subscriber-Interface-Type - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

subscriber-interface-type

Syntax
Release Information
Description
Options
Mode
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
subscriber-interface-type subscriberInterfaceType
no subscriber-interface-type { subscriberInterfaceType | all }
Command introduced in JunosE Release 7.1.0.
Assigns a subscriber-interface type to a QoS parameter definition. Subscriber-interface
types represent subscriber interfaces to which QoS clients can apply QoS parameter
instances obtained through RADIUS, SRC, or QoS profiles. You can specify up to four
subscriber-interface types for each parameter definition. The no version removes the
subscriber-interface type from the parameter definition.
subscriberInterfaceType—One of the following subscriber-interface types: atm-vc, ip,
ipv6, l2tp-session, vlan
all—Removes all subscriber-interface types
QoS Parameter Definition
Configuring a Basic Parameter Definition for QoS Administrators
Chapter 7: S Commands
1239